EWXPW8D2

EWXPW8D2

$249.99

Download Manual

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Out of stock

Categories: EWXPW, Subwoofers

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The double stitched foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

- 2″ High-temperature voice coil
- 120 oz. ceramic ferrite magnet
- High-grade Low Carbon steel on top and bottom plate
- Designed to optimize SPL performance
- High excursion spider designed
- 1.5″ high roll foam surround
- Large gauge push button speaker terminals
- Dual 2 ohm voice coils

Physical Structure

Outside Diameter (A)	8.24″ (209.3mm)
Cutout Diameter (B)	7.14″ (181.35mm)
Mounting Depth (C)	4.23″ (107.44mm)

General Specifications
Structure	8″ (20.32cm) Woofer
Dynamic Power Handling	500 Watts
Nominal Power Handling	250 Watts
Impedance	Dual 2Ω Voice Coil

Parameters
Resonant Frequency (fs)	37.505Hz
D.C. Voice Coil Resistance (Re)	6.9Ω
Mechanical Quality Factor (Qms)	11.453
Electrical Quality Factor (Qes)	0.467
Total Quality Factor (Qts)	0.449
Equivalent Air Volume to Cms (Vas)	3.68 L
Mass of Diaphragm/Coil (Mms)	59.479 g
Force Factor (Bl)	5.451 N/A
Sound Pressure Level (SPL)	85.441 dB

Recommended Enclosures

Woofer Cut-out	7.14″ (181.35mm)
Mounting Depth	4.23″ (107.44mm)
Sealed Box	0.60 ft³ (16.99L)
Vented Box	0.95 ft³ (26.90L)
Vent Area	6 in² (38.70 cm²)
Vent Length	17″ (35.56cm)
Tuning	36Hz
Dynamic Power	500 Watts
Nominal Power	250 Watts

Wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).